Luxul XMS-1024 User Manual download pdf (Page 38)

User Guide

APPENDIX 1: COMMON COMMANDS

Common

Commands

Description

cmd

Enter the command line mode of a Windows system (applicable to

Windows2000 and higher).

ipconﬁ g

Displays the IP address of the computer. (i.e. ipconﬁ g/all) Must be

run from the command line.

ping

Used to test for network availability and device/system recognition.

Device sends a packet to the target host and asks for a response. If

the device receives a response from the target host, it can then see

the network response time and connection status between the local

device and target host. Must be run from the command line.

netstat

Displays details of current active network connections including

routing table and network interface information. Can also be used

to count the active network connections. Must be run from the

command line.

tracert

Displays the path taken by a packet before reaching the target host

and the speciﬁ c time when it reached each node. Similar to the Ping

command but provides more detailed information. Displays the

entire path and IP address of each node in the path and total elapsed

tim. Must be run from the command line.

APPENDIX 2: TCP/IP ADDRESS SETTING (WINDOWS XP)

Select “Start Control Panel (see Figure 1). Select “Classic View” if you do not see the

options below.

Figure 1

1 2 ... 33 34 35 36 37 38 39 40

No comments

Luxul XMS-1024 User Manual Page 38